IC-7200

IC-7200 USB port for PC control. Software Update: Type “USB Driver” Ver.1.00, Icom Support update 17.09.2008

The IC-7200 can be controlled by a PC through a USB port using the CI-V data format. In addition, modulator and received audio can also be transferred over the USB cable. By using appropriate external software, you can record incoming call and/or transmit preprogrammed messages from your PC.

IC-7200 USB port for PC control. Software updates Type: “USB Driver” Ver.1.00, Icom update 17.09.2008
Note: The USB Driver, it is installed in the PC connected to the radio via the USB port (tnx Adam va7oj)

Link to: Icom Global Support/Software Download/IC-7200
Link to: Icom Istallation Guide A-6668-3EX © 2008 Icom Inc.

When the transceiver is connected to a PC with the USB (Universal Serial Bus) cable (third party), the following operations can be performed:
- Remote control operation (CI-V: Icom Communication Interface-V) by the PC, software (third party) may be required;
- Receiver audio output to the PC, format: data 16-bit; Sampling rate 8/11.025/16/22.05/32/44.1/48kHz;
- Modulation imput from the PC, format: data 16-bit; Sampling rate 32/44.1/48kHz;
The receiver audio is always output regardless of the squelch condition (open/close) and output level cannot be adjusted with the [AF] control; The modulation imput can be used when SSB/SSB-D, AM/AM-D mode is in use. From the set  item (DataOFF/Data ON) and USB imput level see p. 77 on the IC-7200 istruction manual for details setting.
Note: Read the New Icom installation guide before installing the USB driver (A-6668-3EX © 2008 Icom Inc.)
Icom, Icom Inc. and the logo are registered trademarks of Icom Incorporated (Japan)

© 2008 I0GEJ’s RadioCronache.com.