IC-7700 update Ver 1.11; Icom have released a new firmware version 1.11 for the IC-7700; Icom Inc. Update 14/09/2009. A description of the changes, download F/W and new User Manual (rev 1EX-2a) appear in the link below – Tks IW0SAF, Moreno for the photo by his Shack!
Icom Major points of the Ver.1.11 update: Improvements in the TX monitor audio level.
[Note] The output of the monitor demod is fed into the main receiver audio amplifier, whose gain is controlled by the AF Gain control. The AF Gain pot is the “master fader”. All Icom transceivers equipped with a monitor circuit are configured in this way……
The IC-7700 firmware upgrade. There is a full instructions of the Updating on p. 16-2 to 16-9 of the User Manual (Section 16 Updating The Firmware), Two methods of firmware update are available: one uses the USB-Memory (USB port and Memory Drive is required), and the other uses a PC (Ethernet cable is required and IP address) – The USB-Memory must have been formatted by the IC-7700 transceiver (FAT/FAT32 formats).
The general rule with FAT vs. FAT32 is this: If your computer has FAT32 capability, use that. Otherwise, use FAT. – There is a full description of the USB memory formatting procedure on p. 12-26 of the User Manual (Section 12 Set Mode – Formatting the USB-Memory)
Link to: Icom co.jp Firmware Updates download – index
Link to: Icom IC-7700 User Manual (A-6612H-1EX-2a) Last update 22/07/2009

IC-7700 aggiornamento del Firmware Ver 1.11; La Icom Inc. ha rilasciato il nuovo aggiornamento per il transceiver IC-7700 in data 14/09/2009. Le istruzioni, le informazioni e il download dei files si scaricano anche accedendo ai link qui sopra.
The firmware version of the IC-7700 can be confirmed during turning power ON • The version appears at the right bottom corner. – Seguire con cura le ampie istruzioni sul manuale utente.
Tag assegnati: Download, Firmware update, Icom, Software, Transceiver
Commenti
Non sono abilitati commenti per questo post.
Comments are closed.