FTdx-5000 Review from RadCom June 10 by G3SJX – Here only some data and a summary

FTdx-5000 measured performance → Source: RSGB RadCom  June, 2010 by G3SJX – Table 1*
[*Note]: here, only some of the many performances misured – View the RadCom Magazine to read the full review by Peter Hart) – !! IP3, IMD3, and Blocking figures were outstanding with the appropriate Roofing filters selected. !! The only area for concern is the receiver spurious signal rejection….

Sensitivity SSB 10dBs-n:n 7MHz band: IPO-1 →0.7uV (-110dBm) PREAMP-1 →0.18uV (-122dBm) PREAMP-2 →0.09uV (-127dBm)
Intermodulation (Spacing 15kHz) 2400Hz bandwidth 6kH Roofing USB 7MHz band: IPO-1 →IP3 +37.5dBm IMD 105dB PREAMP-1 →IP3 +26dBm IMD 105dB PREAMP-2 →IP3 +18dBm IMD 103dB
Close-in Intermodulation on 7MHz Band 500Hz bandwidth CW IPO-1:
Spacing →2kHz (15kHz Roofing) IP3 -8.5dBm IMD 77dB – (6kHz Roofing) IP3 -4dBm IMD 80dB – (3kHz Roofing) IP3 +33dBm IMD 106dB – (600Hz Roofing) IP3 +37dBm IMD 109dB
Spacing →10kHz (15kHz Roofing) IP3 +38dBm IMD 108dB – (6kHz Roofing) IP3 +39dBm IMD 109dB – (3kHz Roofing) IP3 +38dBm IMD 109dB – (600Hz Roofing) IP3 +38dBm IMD 109dB

The 9MHz IF rejection on most bands was greater than 100dB, but on 10MHz it was only 54dB, and on 7MHz it was 74dB. VRF front-end tuning improved these figures by 20dB. The first mixer image was only down by 55dB to 70dB but VRF improved this to better than 75dB.
Spurs on the synthesiser resulted in a number of unwanted receiver responses, notably at approx +/- 425kHz from the received frequency at only 65dB down on the VFO-A rx and at +/- 40kHz down by 85dB. VRF improves these figures but only marginaly on the higher bands.
Third order intercept (IP3), dynamic range (IMD3) and blocking figures were outstanding with the appropriate Roofing filters selected (See the Table-1*). The VFO-B receiver dynamic range is nont quite as good as the VFO-A receiver but is still very respectable.

Link to: The RSGB webpage – RadCom Magazine

La rejezione IF a 9MHz per la maggior parte delle bande risulta superiore a 100dB, ma sulla banda dei 10MHz scende a soli 54dB, e sulla banda dei 7MHz risulta 74dB.- L’uso del VRF tuning del front-end migliora queste figure di circa 20dB. L’immagine del primo mixer risulta attenuata solo da 55 dB a 70 dB, ma con il VRF si ha un miglioramento al valore di 75dB. Le spurie del sintetizzatore produce una serie di risposte indesiderate al di sotto di soli 65dB  rispetto all frequenza  ricevuta,  in particolare a circa +/- 425kHz dal centro della frequenza  sul VFO-A (main rx), ed ancora a +/- 40kHz sono al di sotto di 85dB. L’inserimento del circuito VRF migliora queste cifre, però solo marginalmente sulle bande più alte di frequenza.
L’intercept point di terzo ordine (IP3), la gamma dinamica  IMD3 e la dinamica di blocco hanno valori che variano in base alla banda passante  del Roofing filter selezionato (Vedere Tabella-1*). Il ricevitore del VFO-B (sub rx) ha a sua volta una dinamica non altrettanto buona come il  ricevitore VFO-A (main rx), ma comunque è  molto rispettabile. – !! Emerge dall’articolo di Peter  Hart una questione che lo preoccupa:  la effettiva capacità di rejezione di segnali spuri del  ricevitore A.
[Note]: RSGB Members Only can now download the June, 2010 RadCom Review  in PDF format.

IC-7600 Review RadCom a summary available. New Icom User Manual En 1EX-1 Update 2009/07/23!

Radcom June 2009 G3SJX review IC-7600 Measured Performance. Summary available: Close-in IMD, IP3 on 7MHz Band, 2.4kHz Bandwidth, USB mode. Preamp Off. – In the receiver, close-in IMD3 dynamic range, reciprocal mixing noise, MDS (sensitivity), IF filter bandwidth (selectivity) and in-band IMD are important parameters.  A summary can be made available in this table IMD3, IP3 report….. Watch the report table, below.

ICOM, has released new IC-7600 User Manual En A-6722H-1EX-1 (auditing) – Last Update 2009/07/23 ……. See the Link below (for download)

ICOM  ha rilasciato un nuovo Manuale Utente per l’IC-7600 in Inglese (1Ex-1 auditing) il 23.07.09 – (ci sono integrazioni  operative più chiare, con variazioni su molte pagine)…. Più avanti il Link e la tabella con IMD, IP3  in 7MHz con filtro 2,4kHz in USB …. (continua…)

IC-7700 RSGB review summary, RadCom July 2008

RadCom reviews: IC-7700.  Queste le conclusioni di Peter Hart, G3SJX che ha curato la recenzione per la RSGB, in merito all’analisi dell’Icom IC-7700:
“The IC-7700 is without doubt a most impressive radio. Its performance, its features and its ergonomics place it high in the top league. As a general purpose and contest radio it is excellent, but for serious DXing with split frequency operation the lack of a second channel receive capability or dual-watch is a major shortcoming, particularly with a price tag around 4,000 UK Pounds. It all depends where your interests lie as to which features are most important”.

Link to: Radcom RSGB (Radio Society of Great Britain) Home Page